Sanyo WXU700 Instruction Manual, PLC-WXU700 Network Set Up Macintosh - Page 84
Status, Change the mode of the registered projector, Description, Operation
UPC - 086483074219
View all Sanyo WXU700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Chapter 7 Controlling the projector Change the mode of the registered projector To change the mode of the registered projector, select a mode with the pull-down menu button under the IP address of the target projector and then click Set button. Mode Operation Control Controlling the projector Control & Image Controlling and displaying images Image Displaying the images OFF Excluding from the multi-control Delete Deleting from the multi-control * The multi control item is not available with the light mode. Status If some of the registered projectors are disabled by some reasons (such as disconnecting the power source, disconnecting the LAN cable, disconnecting from the network), control changes will continue to be effective for the projectors that are still active. At the same time, the deactivated projectors are excluded from the multi-control. The status of the registered projectors are indicated under the projector name. See the table below for status indications. Status Status Description (blank The projector is connected to the network correctly No connect The projector may not be connected to the network. Please check the connection and network configuration of this projector. PIN code error The PIN code is incorrect. The PIN code for the multi-controlled projectors must be the same. Change the PIN code of this projector to the common PIN code. (p.32, p.42) File Error Not displaying the images. Check if this projector is using the Network Capture function, or in the standby mode. * The projector updates the status at the time when the multi-control function is executed. ✐ If the multi-controlled projector is in the standby mode, items of "PC adj.", "Control" and "Setting" cannot be operated. ✐ It is recommended that a specified projector should be chosen for setting as a master when you use this multicontrol function. The control for the multi-controlled projectors will become too complicated operation if this function is used for each projector. ✐ If the registered projector is not connected to the network, it will take a while to complete the multi-control operation because of waiting for the response from each registered projector. ✐ There are some disabled items in the multi-control function for the light mode. 84