Schwinn 570E Elliptical Assembly and Owner s Manual - Page 45

Condition/Problem No speed/RPM reading, Console displays "Please Stride" error code Console shuts off (enters sleep mode) while in use Fan will not turn on or will not turn off Fan will not turn on, but Console operates Unit rocks/does not sit level Foot pedals loose/unit difficult to operate Drive train click/tick noise once per full crank revolution Things to Check Solution Check data cable integrity All wires in cable should be intact. If any are cut or crimped, replace cable. Check data cable connections/orientation Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check electrical (wall) outlet Check connection at front of unit Check data cable integrity Check data cable connections/orientation Reset machine Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check data cable integrity Check data cable connections/orientation Reset machine Check for blockage of fan Check leveler adjustment Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Make sure unit is plugged into a functioning wall outlet. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. All wires in cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Unplug unit from electrical outlet for 5 minutes. Remove material from fan. If necessary, detach the Console to help with removal. Replace the Console if unable to remove blockage. Adjust levelers until machine is level. Check surface under unit Hardware Check crank/pulley assembly Check foot assemblies, leg assemblies, handlebar assemblies Check for loose hardware Adjustment may not be able to compensate for extremely uneven surfaces. Move machine to level area. Tightly secure all hardware on the Pedal Arms and Handlebar Arms. Disconnect left and right foot assemblies and rotate crank. If sound persists, replace crank/pulley assembly. If sound does not come from rotating crank, check foot assemblies and upper/lower handlebars. Manually move foot, leg, and handlebar assemblies to isolate sound. Replace part making sound. Tightly secure all hardware on the Stabilizers and the base of the Console Mast. 45