Schwinn 570E Elliptical Assembly and Owner s Manual - Page 46
Handlebar Arm and Pedal
View all Schwinn 570E Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Condition/Problem Knocking sound during machine operation Squeaking noise that appears a few minutes into a workout and normally will get progressively worse as the workout continues Knocking sound during machine operation. Incline assembly sticks/ difficult to adjust Things to Check Check hardware at junction between Lower Handlebar Arm and Pedal Bolt that connects the swing arms to the axle running through the console mast Solution Make sure that the alignment tab on the Pivot Sleeve goes into the slot in the hole. Be sure the Pivot Sleeve extends through the opposite hole in the joint cover. Loosen pivot rod bolt slightly until noise goes away. White lithium grease can also be applied for a temporary fix. Contact your local distributor for assistance. Roller squeaking on rail Apply silicone lubricant to a dry cloth and wipe the rails to eliminate roller noise. Check hardware at Make sure that the alignment tab on the Pivot Sleeve goes into junction between Lower the slot in the hole. Be sure the Pivot Sleeve extends through Handlebar Arm and Pedal. the opposite hole in the joint cover. Check position of incline assembly Adjust levelers to raise the front of rail assembly until there is 0.6cm - 1.25cm (1/4" - 1/2") space between the top of the incline assembly and the main unit shroud. 46