Schwinn 570T Treadmill Assembly and Owner s Manual - Page 53
Condition/Problem, Things to Check, Solution
View all Schwinn 570T Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Condition/Problem Fan will not turn on or will not turn off Fan will not turn on, but Console operates Unit rocks/does not sit level Thumping sound when belt operates Walking belt not aligned Motor sounds strained Hesitation or walking belt slips when in use Belt stops moving while in use Things to Check Check data cable connections/orientation Reset machine Reset machine Check for blockage of fan Check leveler adjustment Check surface under unit Walking belt Machine leveling Walking belt tension and alignment Silicone lubrication on walking belt Belt tension Safety key Motor overload Solution Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. If the above steps do not resolve the problem, contact your local distributor for further assistance. Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet. Unplug unit from electrical outlet for 5 minutes. Remove material from fan. If necessary, detach the Console to help with removal. Replace the Console if unable to remove blockage. Adjust levelers until machine is level. Adjustment may not be able to compensate for extremely uneven surfaces. Move machine to level area. Walking belt needs to be used for wear in period. Sound will go away after the wear in period. Make sure the machine is level. Refer to the procedure for leveling the machine in this manual. Make sure the walking belt is centered and tension is correct. Refer to the procedures for adjusting tension and aligning the belt in this manual. Apply silicone to the inner surface of the walking belt. Refer to the belt lubrication procedure in this manual. Adjust the belt tension at the rear of the machine. Refer to the procedure for adjusting belt tension in this manual. Plug Safety Key into Console. (See Emergency Stop Procedure in the Important Safety Instructions section.) Unit may be overloaded and draw too much current, which causes power to turn off to protect motor. Refer to maintenance schedule for belt lubrication. Make sure the walking belt tension is correct, and start unit again. If the above steps do not resolve the problem, contact your local distributor for further assistance. 53