Schwinn Airdyne Evolution Comp Owner's Manual - Page 17

Fig. 6 Fig. 7 Fig. 8 Fig. 9  Moving Your Airdyne/Evolution Comp Bike To move the Airdyne bike, carefully lift the rear end of the bike and teer it to another location. Be gentle while moving the unit as any sharp impact directly or indirectly to the computer can affect operation (Fig 6).  Installing New Computer Batteries Your Airdyne/Evolution Comp computer comes complete with fresh batteries already installed. Signs that battery power is low include: fading LCD display; erratic function; or failure to turn on when the ON/OFF button is pushed or when the pedals are put into motion. To install new AA batteries, just pop open the battery door in the back of the computer (Fig. 7).  Adjusting the Drive Chain or Belt Tension The drive chain and belt tension on your Airdyne bike have been factory adjusted. They should not require any immediate attention. If they need further adjustment at any point in time, contact your authorized Schwinn dealer.  Fanwheel alignment The fanwheel alignment on your Airdyne bike has been factory adjusted. It should not require any immediate attention. If it does need further adjustment at any point in time, contact your authorized Schwinn dealer.  Leveling your Airdyne/Evolution Comp Bike The Airdyne/Evolution Comp Bike can be leveled to compensate for uneven surfaces. To level the bike, raise or lower the four leveling bolts located on the underside of the legs by screwing them in or out as needed (Fig. 8).  Locking your Airdyne/Evolution Comp Bike A locking device has been provided to prevent the drive mechanism from rotating accidentally. To lock the Airdyne, rotate the knob on the fan cage clockwise until the stop engages the fanwheel. It is now securely locked in place (Fig. 9). To unlock the bike, rotate the knob counterclockwise until the stop is completely clear of the fanwheel. To reduce the risk of accidental injury, always engage the locking mechanism when the bike is not in use. NOTE: if you hear a clicking noise while exercising, make certain that the locking knob is completely unscrewed and clear of the fanwheel.  Maintenance Use a damp cloth to wipe your Airdyne/Evolution Comp Bike and computer free of sweat. IMPORTANT: To avoid damaging the finish on your Airdyne/Evolution Comp Bike and computer, never use a petroleum-based solvent when cleaning. Avoid getting excessive moisture on the computer. 17 MAINTENANCE