Sennheiser XSW-D LAVALIER SET Instruction manual - XS Wireless Digital PDF - Page 58
you have to adjust the input level on the camera.
View all Sennheiser XSW-D LAVALIER SET manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Operation tery first. If the status LED flashes red, the charge level is too low. You have to charge the rechargeable battery first (see „Charging the rechargeable battery"). After four seconds, the status LED starts flashing green. The flashing indicates that a wireless connection is being established. The status LEDs remain green once the transmitter and receiver are connected. If the status LEDs do not remain green, either the charge level is below 15% (see „Checking the charge level during use") or the transmitter and receiver are not paired (see „Pairing"). Switching off the transmitter and receiver ► ▷ Press the button on the transmitter and the button on the receiver until the status LEDs switch off. Adjusting the input level on the camera Once you have connected the receiver to the camera and switched it on, you have to adjust the input level on the camera. ► ▷ If the camera has automatic gain control (AGC), you should disable this function. ▷ Set the input level in the camera's menu so that the audio signal does not overload the input. ▷ During recording, regularly check the input level on the camera to make sure that the audio signal is not overloading. 57