Sharp AF-08CRL Service Manual - Page 11

AF-08CRL USING THE REMOTE CONTROL INSTALLING BATTERIES Use two size-AAA (R03) batteries. 1 Remove the battery compartment cover. 2 Insert the batteries in the compartment, making sure the and polarities are properly aligned. Battery compart- 3 Replace the cover. ment cover NOTES: • The battery life is approximately one year with normal use. • When you replace the batteries, always use two new ones of the same type. • If the remote control does not operate normally after replacing the batteries, take out the batteries and replace them again after 30 seconds. • If you will not be using the unit for a long time, remove the batteries from the remote control. ATTACHING THE REMOTE CONTROL HOOK • Remove the backing from the remote control hook. • Attach the hook onto the left side of the unit's front cabinet. • To prevent loss, hook the remote control on the front cabinet when not in use. Rear Cabinet Front Cabinet Remote control hook HOW TO USE THE REMOTE CONTROL Point the remote control towards the unit's re- ceiver window and press the desired button. A beep will sound when the unit receives the signal. • Make sure no objects, such as curtains, block the receiver window. • The remote control operates from up to 20 feet (6 meters) away. • The beep will also sound when each pad on the control panel is touched. CAUTION: • Do not expose the receiver window to direct sunlight. This can adversely affect its operation. In such case, close the curtains to block the sunlight. • Use of a fluorescent lamp in the same room may interfere with the transmission of the signal. • The unit may be affected by signals emitted from the remote control of a television, VCR or other equipment used in the same room. • Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote control from moisture and shock which can discolor or damage it. 11