Sharp LC-20SH7U LC-20SH7U Operation Manual - Page 14

INITIAL SETTING These operations are accessible by remote control. Some may also be accessible by controls on the main unit. 5 Initial Setup This section will guide you through the unit's initial setting which includes selecting a language for your on-screen menu and "AUTO PRESET CH", which automatically scans and memorizes viewable channels. Before you begin: Make sure if the unit is connected to antenna or cable. 1 After making all the necessary connections, press [POWER] to turn on the unit. POWER • This operation may take a few moments. 2 Use [Cursor K/L] to select the on-screen language from the choices on the right side of the TV screen. (ENGLISH / ESPAÑOL / FRANÇAIS) or ENTER SELECT LANGUAGE SELECCIONE EL IDIOMA CHOISIR LA LANGUE ENGLISH ESPAÑOL FRANÇAIS SELECT : K,, L SELECCIONE : K,, L CHOIX : K,, L SET : ENTER AJUSTE : ENTER VALIDER : ENTER Note: • If you connect the cable system directly, contact the CATV installer. • If you press [POWER] or [MENU] during "AUTO PRESET CH", this setting will be canceled. • The initial auto channel scan function can be executed for either TV/DTV or CATV only once. If you want to scan both TV/DTV and CATV, you need to select "CHANNEL SETUP" in the main menu to scan and memorize other channels after initial presetting is completed. (Refer to page 13.) • You can cancel or exit the initial "AUTO PRESET CH" menu by pressing [MENU]. • When no channel can be received by "AUTO PRESET CH", "NO TV SIGNALS" is displayed on the TV screen. • If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the unit, "HELPFUL HINTS" appears. Follow the instructions listed on the TV screen. - HELPFUL HINTS 1. PLEASE CHECK TO SEE IF THE ANTENNA/CABLE IS PROPERLY CONNECTED. 2. DID YOU PERFORM ˝AUTO PRESET CH˝? • "INITIAL SETUP" menu on step 3 will be displayed in the selected language after you press [ENTER]. 3 Use [Cursor K/L] to select "AUTO PRESET CH(TV/DTV)" for TV channels or "AUTO PRESET CH(CATV)" for CATV channels, then press [ENTER]. or ENTER - INITIAL SETUP - PLEASE CONNECT ANTENNA OR CABLE TO THIS UNIT. AUTO PRESET CH(TV/DTV) AUTO PRESET CH(CATV) SELECT: K , L SET : ENTER • Scanning and memorizing the channels automatically start. 25 AUTO PRESET CH(TV/DTV) • When the scanning and memorizing are completed, the lowest memorized channel in the broadcasting will be displayed. 12 EN