Sharp LD-26SH3U LD-26SH3U Operation Manual - Page 27

Connecting the TV to a computer Digital connection Connect the separately-sold digital signal cable (model name: NL-C04J) to the digital RGB output terminal of the computer. See page E10 for information on removing/ replacing the terminal cover. - The TV has an input terminal for connecting to a computer with a DVI-compatible output terminal (DVI-D 24 pin or DVI-I 29 pin). (Depending on the type of computer to be connected, the display may not work correctly.) DVI input terminal (DVI-D 24 pin) Computer Notes: - The DVI input terminal is used for either AV equipment or a computer. Before using this terminal, you need to set "DVI Select" to "PC" in the Option menu. The factory setting is "AV". (See page E45 or E52.) After making the connection, follow the procedure below. (Make sure that the connected computer is switched off.) 1. Press the POWER button to turn on the TV. (See page E28.) 2. Press the MENU button to display the MENU screen. (See pages E42 and E45, or E47 and E52 for information on using the menus.) 3. Select the Option menu. 4. Set "DVI Select" to "PC". 5. Press the MENU or EXIT button to exit the screen. 6. Press the INPUT or PC button to select "PC DIGITAL" as the display mode. (See page E29 for information on switching display modes.) 7. Turn on power to the connected computer. - If the image does not appear properly, turn off power to both the TV and the connected computer. Again, set "DVI Select" to "PC" following steps 1 through 7 above. Digital RGB output terminal (DVI-D 24 pin or DVI-I 29 pin) Digital signal cable (separately-sold) - Paying attention to the connector direction, firmly insert the signal cable straight into the connector, and then tighten the screws at both ends. Connecting the audio cable Connect the supplied PC audio cable to the audio output terminal of the computer. See page E10 for information on removing/ replacing the terminal cover. PC audio input terminal Computer Audio output terminal PC audio cable (supplied) E26