Sharp PG-M15X PG-M15S , PG-M15X Operation Manual - Page 54

RS-232C Port Specifications PC control A computer can be used to control the projector by connecting an RS-232C cable (null modem, cross type, sold separately) to the projector. (See page 17 for connection.) Communication conditions Set the serial port settings of the computer to match that of the table. Signal format: Conforms to RS-232C standard. Baud rate: 9,600 bps Data length: 8 bits Parity bit: NON Stop bit: 1 bit Flow control: None Basic format Commands from the computer are sent in the following order: command, parameter, and return code. After the projector processes the command from the computer, it sends a response code to the computer. Command format C1 C2 C3 C4 P1 P2 P3 P4 Return code (0DH) Command 4-digit Response code format Normal response Parameter 4-digit O K Return code (0DH) Problem response (Failure due to incorrect command/parameter or the other communication errors) E R R Return code (0DH) When more than one code is being sent, send each command only after the OK response code for the previous command from the projector is verified. • When using the computer control function of the projector, the projector operating status cannot be read to the computer. Therefore, confirm the status by transmitting the display commands for each adjustment menu and checking the status with the On-screen Display. If the projector receives a command other than a menu display command, it will execute the command without displaying the On-screen Display. Commands EXAMPLE • When INPUT SWITCHING is set to INPUT 1 (DVI). Computer I RGB _ _ _ 1 → ← Projector OK CONTROL ITEM POWER SETTING INPUT SWITCHING COMMAND PARAMETER C1 C2 C3 C4 P1 P2 P3 P4 CONTROL CONTENTS P O W R _ _ _ 0 POWER OFF (STANDBY) P O W R _ _ _ 1 POWER ON I R G B _ _ _ 1 INPUT1 (DVI) I R G B _ _ _ 2 INPUT1 (RGB) I R G B _ _ _ 3 INPUT1 (COMPONENT) I V E D _ _ _ 1 INPUT2 (S-VIDEO) I V E D _ _ _ 2 INPUT3 (VIDEO) • If an underbar (_) appears in the parameter column, enter a space. Appendix 52