Singer Futura Quartet Instruction Manual - Page 36

Preparing The Machine Before, Installing The Hoop, Attaching And Removing, Embroidery Hoop - embroidery needles

Page 36 highlights

PREPARING THE MACHINE BEFORE INSTALLING THE HOOP 1 1. Turn hand wheel counter clockwise (toward you) until the needle comes to its highest position. ATTACHING AND REMOVING EMBROIDERY HOOP 1 (A) 1. Raise presser foot and needle, and push up lever (A) of embroidery foot with your finger and pass embroidery hoop under it.  To remove, pull the hoop forward to slide it out from underneath the embroidery foot. 2. Slide the hoop onto the embroidery unit from front to back until it clicks into place. 2  To remove, press the release lever and slide the hoop towards you. NOTE: Before attaching small hoop, turn on power switch to move the carriage to embroidering standby position. Carriage Hoop mounting plate Hoop release lever 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

36
PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel counter clockwise (toward you) until the
needle comes to its highest position.
1
ATTACHING AND REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) of
embroidery foot with your finger and pass embroidery hoop
under it.
To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
To remove, press the release lever and slide the hoop
towards you.
NOTE:
Before attaching small hoop, turn on power switch to
move the carriage to embroidering standby position.
(A)
2
1
Hoop release lever
Carriage
Hoop mounting plate