Sony BVMF170A User Manual (Operating Instructions - BVM-F250A / BVM-F170A) - Page 23
Version of the Controller, Installing an Input Adaptor (BVM-F250A
View all Sony BVMF170A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 2 Preparations Version of the Controller To use all the functions of the monitor, the controller (BKM-16R) with software version 1.7 or higher is required. Certain functions of the monitor cannot be controlled if the controller with a lower version is used. Installing an Input Adaptor (BVM-F250A) 1 Loosen two screws and remove the cover of an input option port on the side panel of the monitor. Cover of an input option port Make sure the MAIN POWER switch is turned off, and disconnect the AC power cord. Off 2 Insert the adaptor facing the board as shown below. Board 3 Push the adaptor in until it is firmly fit into the connector inside the monitor, then tighten the two screws to secure the adaptor. 23 Version of the Controller / Installing an Input Adaptor (BVM-F250A)