Sony BVMF170A User Manual (Operating Instructions - BVM-F250A / BVM-F170A) - Page 32
Turning on the Power (BVM-F170A), Connecting to Power
View all Sony BVMF170A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Chapter 2 Preparations Turning on the Power (BVM-F170A) Connecting to Power The warm-up time is more than 30 minutes, approximately. When the monitor is in standby mode As the OPERATE lamp lights in red in standby mode, press the MONITOR I/1 switch of the controller. The OPERATE lamp lights in green and the monitor enters operation mode. You can operate the monitor with AC or DC power supply. To connect the AC power cord 1 Plug the AC power cord into the AC IN connector on the rear panel. Then, attach the AC plug holder (supplied) to the AC power cord. AC power cord (supplied) AC plug holder (supplied) Attach the AC plug holder to the AC power cord, and connect the cord to the AC IN connector so that the cord does not come loose. 2 Slide the AC plug holder over the cord until it locks. 32 Turning on the Power (BVM-F170A) To disconnect the AC power cord Pull out the AC plug holder while pressing the lock levers. To connect the DC power supply Connect the DC power supply to the DC IN 24 V - 28 V connector. When the AC power cord and DC power supply are connected, the AC power supply is given preference to