Sony CSS-HD1 Instruction Manual - Page 11
Set up, Preparing the remote control, Preparing the Cyber-shot Station - camera
UPC - 027242701175
View all Sony CSS-HD1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Set up Preparing the Cyber-shot Station 1 Set the MODEL SELECT switch. See the table below and set the MODEL SELECT switch to match with your camera. MODEL SELECT switch ( , ) DSC-W200, DSC-W90, DSC-W85, DSC-W80 DSC-T100, DSC-T25, DSC-T20 2 Connect the AC Adaptor to the DC IN jack of the Cyber-shot Station. Cyber-shot Station To use your Cyber-shot Station abroad - Power sources You can use the Cyber-shot Station and the AC Adaptor (supplied) in any country or region where the power supply is within 100 V to 240 V AC 50/60 Hz. Use a commercially available AC plug adaptor, if necessary, depending on the design of the wall outlet (wall socket). AC plug adaptor (not supplied) Do not use an electronic transformer (travel converter), as this may cause a malfunction. Preparing the remote control Notes on the remote control The remote control is powered by a button type lithium battery (CR2025) installed at the factory. An insulation sheet is inserted to avoid the battery exhaustion. Remove the insulation sheet before using the remote control for the first time. DC plug Insulation sheet AC Power cord (mains lead) AC Adaptor To a wall outlet (wall socket) Point the remote sensor of the Cyber-shot Station away from strong light sources such as direct sunlight or overhead lightings. Otherwise, the remote control may not function properly. The remote control range is less than five meters (for indoor use). Point the remote control at the remote sensor of the Cyber-shot Station. Try adjusting the angle of the remote control if you cannot operate the Cyber-shot Station. 11-GB