Sony CSS-HD1 Instruction Manual - Page 14

Slide Show You can playback a series of still images and movies recorded with your camera by only pressing the SLIDE SHOW button on the remote control. 1 Turn on the power by pressing the (playback) button of the camera or the POWER button on the remote control. 2 Press the SLIDE SHOW button on the remote control. To cancel Slide Show Press the SLIDE SHOW button on the remote control again.  You can change the settings of Slide Show ([Interval], [Image], and [Repeat] etc.) with the settings on the camera. For further details, refer to the operating instructions supplied with the camera. Care and maintenance Clean the Cyber-shot Station with a soft cloth slightly moistened with water, and wipe the surface with a dry cloth. Do not use any type of solvent such as thinner, alcohol or benzine as this may damage the surface. CAUTION Replace the battery with the specified type only. Otherwise, fire or injury may result. Replacing the button type lithium battery * Do not use any batteries other than CR2025. 1 Pull out the battery holder while pushing the tab on the holder. 2 Take out the button type lithium battery from the holder. 3 Put a new battery into the holder with its + side facing upward. Changing the battery of the Remote Control WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire.  When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion. For the State of California, USA only Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate Perchlorate Material: Lithium battery contains perchlorate. 4 Insert the holder into the remote control until it clicks. 14-GB