Sony DSCU60 Operating Instructions - Page 67

Symptom, Cause, Solution, Others

Page 67 highlights

Others Symptom Cause Your camera does not work. • The battery level is low. (The E indicator appears.) • The USB cable is connected. The power is on, but the camera does not work. • The built-in microcomputer is not working properly. You cannot identify an - indicator on the LCD screen. The lens portion gets fogged. • Moisture condensation has occurred. Solution p Charge the batteries (page 10). p Disconnect the USB cable (pages 54 and 59). p Remove the batteries, then install them again after about one minute and turn on the camera. If the functions still do not work, open the waterproof cover to press the RESET button using a fine-tipped object, then close the cover and turn the power on again (page 61). (If you press the RESET button, all settings including the date and time are cleared.) p Check the indicator (pages 83 and 84). p Turn off the camera and leave it for about an hour at the room temperature for the moisture to evaporate before use (page 75). Troubleshooting 67

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88

67
Troubleshooting
Others
Symptom
Cause
Solution
Your camera does not work.
The battery level is low. (The
E
indicator
appears.)
The USB cable is connected.
p
Charge the batteries (page 10).
p
Disconnect the USB cable (pages 54 and 59).
The power is on, but the
camera does not work.
The built-in microcomputer is not working
properly.
p
Remove the batteries, then install them again after about one
minute and turn on the camera. If the functions still do not work,
open the waterproof cover to press the RESET button using a
fine-tipped object, then close the cover and turn the power on
again (page 61). (If you press the RESET button, all settings
including the date and time are cleared.)
You cannot identify an
indicator on the LCD screen.
p
Check the indicator (pages 83 and 84).
The lens portion gets
fogged.
Moisture condensation has occurred.
p
Turn off the camera and leave it for about an hour at the room
temperature for the moisture to evaporate before use (page 75).