Sony DSR 45 Operating Instructions - Page 96
The CHARACTER DISPLAY LCD selector has been set to ON BLACK BACK., Symptom, Cause/Remedy
UPC - 027242603998
View all Sony DSR 45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Chapter 7 Maintenance Troubleshooting Symptom Cause/Remedy When you set the INPUT LEVEL selector: • You do not know how to adjust the input level. • The recorded level is too low. • The recorded sound is distorted. Confirm the level of the sound output from the player by referring to the player's instruction manual. According to that output level, set the INPUT LEVEL selector on the rear panel of this unit so as to obtain an optimum level. If you are not clear about the player's output level, try the following procedure. 1 Specify the output level by types of audio output connectors available on the player. • If the player is equipped with phono jacks: Set the INPUT LEVEL selector to -10. • If the player is equipped with XLR connectors: Set the INPUT LEVEL selector to +4 or -2. 2 Set the AUDIO INPUT switch on the front panel to MANU and adjust the AUDIO REC LEVEL control knobs to a median value. Then, play back the tape which you intend to use for playback. When the playback audio level is at its maximum, if the audio levels meters exceed 0 dB, set the INPUT LEVEL selector to the lower step (+4 or -2) or turn the AUDIO REC LEVEL control knobs to adjust the recording level. The recorded sound at the portion where the meters exceed 0 dB will be distorted. The unit does not function as part of a digital non-linear editing system. • The INPUT SELECT selector is set to a setting other than DV. t Set it to DV. • The editing controller or the editing software is not compatible with this unit. t Refer to the instruction manuals of the controller or the software and consult their manufacturers. An editing point cannot be located using an editing controller connected to the RS422A connector. • Set FF/REW SPD on the VTR SET menu to SHUTTLEMAX. If this item has been set to FF/REW, some editing controllers that are not compatible with the rewinding / fast-forwarding speeds of this unit may not be able to locate an editing point. • If the tape has a portion where the time code is not continuous or is not recorded, an editing point may not be located. • This unit only can edit using the time code. If you choose to edit using the CTL signal, it may not be possible to locate an editing point. • If you use a PAL formatted tape in the DSR-45 (or use an NTSC formatted tape in the DSR-45P) or a tape with both NTSC and PAL color system recordings, it may not be possible to locate an editing point accurately. The unit cannot be operated using a device connected to one of the connectors in the remote control section. The setting of the remote selector is not appropriate. t Set the remote selector according to the connector you are using. If the unit cannot be operated even though the remote selector is set appropriately, press the RESET button located on the bottom of the unit. However, if you do this, the time set in the internal clock and the time code of the FREE RUN setting will be initialized. No picture on the LCD monitor. The CHARACTER DISPLAY (LCD) selector has been set to ON (BLACK BACK). t Set it to ON. 96 (GB) Chapter 7 Maintenance