Sony DSR 45 Operating Instructions - Page 97

Chapter 7 Maintenance Alarm Messages If an error occurs, a warning appears on the LCD monitor and the MONITOR VIDEO output (if the CHARACTER DISPLAY (MONITOR OUT) switch is set to ON). Check them with the following list. LCD monitor Beep %Z DEW DETECTED Q NO TAPE Q QZ TAPE END QZ REC INHIBIT Beep Beep No beep Beep Beep REC MODE NOT DVCAM Beep 16BIT OR NO REC TAPE Beep DV IN SELECTED CLOCK SET Beep No beep COPYRIGHT PROTECTED Beep x HEAD CLOG Y Displayed alternately No beep CLEANING CASSETTE Z Beep Display window Description/Recovery Moisture condensation t Remove the cassette, then wait more than one hour Err with the unit powered on. Err You tried to record without a cassette. t Insert a cassette. - The tape is reaching the end during recording. t Provide a new cassette. Err The tape reached the end and still tried to record. t Rewind the tape or replace the cassette with a new one. The cassette is write-protected. (The REC/SAVE switch is set to SAVE.) t Set the Err REC/SAVE switch to REC or use another cassette (See page 30 (GB)). You tried to dub the sound onto a tape that is not DVCAM-formatted. t Use a Err DVCAM-formatted tape on which the sound has been recorded in the 32 kHz audio mode (4-channel/12 bits). You tried to dub the sound onto a blank tape or onto a tape on which the sound was not recorded in the 32 kHz audio mode (4-channel/12 bits). t Use a Err DVCAM-formatted tape on which the sound has been recorded in the 32 kHz audio mode (4-channel/12 bits). You tried to dub the sound when the INPUT SELECT selector has been set to Err DV. t You cannot dub the sound in the DV input mode. Select another input mode. - You did not set the clock when you turned on the unit. t Set the clock using the menu (See page 92 (GB)). You tried to record a copyright protected source. t You cannot record a Err copyright protected source (See page 32 (GB)). The video heads are clogged. t Clean the video heads with the supplied cleaning cassette. (The unit can detect if the video heads are clean only before recording. If the video heads get clogged during recording, the unit cannot detect Err it.) - a) The unit is running the self-diagnostics (See page 100 (GB)). a) A self-diagnostics code number (see page 100 (GB)) is displayed on the display window. 97 Chapter 7 Maintenance (GB)