Sony DVP-F21 Operating Instructions - Page 72
Setting the digital output signal, AUDIO DRC Dynamic Range, Control DVD only, DOWNMIX DVD only
View all Sony DVP-F21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
xAUDIO DRC (Dynamic Range Control) (DVD only) Makes the sound clear when the volume is turned down when playing a DVD that has the "AUDIO DRC" function. This affects the output from the following jacks: - AUDIO OUT L/R jacks - DIGITAL OUT (OPTICAL) jack only when "DOLBY DIGITAL" is set to "DPCM" in "DIGITAL OUT" (page 73). STANDARD Normally, select this position. TV MODE Makes the low sounds clear even if you turn the volume down. It is especially recommended when you listen to the sound using the speakers of the TV. WIDE RANGE Gives you the feeling of being at a live performance. When you use high quality speakers, it is even more effective. xDOWNMIX (DVD only) Switches the mixing down methods when you play a DVD on which rear signal components such as "Rear (L)," "Rear (R)," or "Rear (Monaural)" are recorded in Dolby Digital format. For details on the rear signal components, see "Changing the Sound" (page 51). This function affects the output of the following jacks: - AUDIO OUT L/R jacks - DIGITAL OUT (OPTICAL) jack when "DOLBY DIGITAL" is set to "D-PCM" in "DIGITAL OUT" (page 73). DOLBY Select this when the player is SURROUND connected to an audio component that conforms to Dolby Surround (Pro Logic). The output signals which reproduce the Dolby Surround effect are downmixed to 2 channels. NORMAL Select this when the player is connected to an audio component that does not conform to Dolby Surround (Pro Logic). All of the output signals are downmixed to 2 channels without the Dolby Surround (Pro Logic) effect. xDIGITAL OUT Selects if audio signals are output via the DIGITAL OUT (OPTICAL) jack. ON OFF Normally, select this position. When you select "ON," set "DOLBY DIGITAL" and "DTS." For details on setting these items, see "Setting the digital output signal." The player does not output the audio signals via the DIGITAL OUT (OPTICAL) jack. The influence of the digital circuit upon the analog circuit is minimal. Setting the digital output signal Switches the method of outputting audio signals when you connect the following component using an optical digital cord via the DIGITAL OUT (OPTICAL) jack. - Amplifier (receiver) with digital input jack - Amplifier (receiver) with a built-in DTS or DOLBY DIGITAL decoder - MD or DAT deck For connection details, see page 24. Select "DOLBY DIGITAL" and "DTS" after setting "DIGITAL OUT" to "ON." AUDIO SETUP AUDIO ATT: OFF AUDIO DRC: STANDARD DOWNMIX: DOLBY SURROUND DIGITAL OUT: ON DOLBY DIGITAL: D-PCM DTS: OFF 72