Sony DVP-NC600 Operating Instructions (DVP-NC600 CD/DVD Player) - Page 50

• Dolby Digital 3 ch DOLBY DIGITAL 2 / 1 Front (L/R) Rear (monaural) • PCM (Stereo) Sampling frequency PCM 96kHz 24bit Quantized bit rate About audio signals Audio signals recorded in a disc contain the sound elements (channels) shown below. Each channel is output from a separate speaker. • Front (L) • Front (R) • Center • Rear (L) • Rear (R) • Rear (Monaural): This signal can be either the Dolby Surround Sound processed signals or the Dolby Digital sound's monaural rear audio signals. • LFE (Low Frequency Effect) signal Note If "DTS" is set to "OFF" in "AUDIO SETUP," the DTS track selection option will not appear on the screen even if the disc contains DTS tracks (page 68). TV Virtual Surround Sound Settings (TVS) When you connect a stereo TV or 2 front speakers, TV Virtual Surround lets you enjoy surround sound effects by using sound imaging to create virtual rear speakers from the sound of the front speakers (L: left, R: right) without using actual rear speakers. This function is designed to work with the LINE OUT L/R (AUDIO) 1/2 jacks. Note that if you select one of the TVS settings while playing a DVD, the player does not output the Dolby Digital signals from the DIGITAL OUT (COAXIAL or OPTICAL) jack (when you set "DOLBY DIGITAL" in "AUDIO SETUP" to "D-PCM") (page 68). SURROUND 1 Press SURROUND during playback. The Control Bar is displayed. TVS DYNAMIC 2 Press SURROUND repeatedly to select one of the TVS (TV Virtual Surround) sounds. Refer to the explanations given for each item. • TVS DYNAMIC • TVS WIDE • TVS NIGHT • TVS STANDARD 50