Sony FW-55BZ35F Reference Guide - Page 3

NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced with the same rating of fuse approved by ASTA or BSI to BS 1362 (i.e., marked with or ) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. FUSE How to replace the fuse Open the fuse compartment with a blade screwdriver, and replace the fuse. Please refer to the illustration that actually equipped with the product. IMPORTANT NOTICE This product has been manufactured by or on behalf of Sony Visual Products Inc. EU Importer: Sony Europe B.V. Inquiries to the EU Importer or related to product compliance in Europe should be sent to the manufacturer's authorized representative, Sony Belgium, bijkantoor van Sony Europe B.V., Da Vincilaan 7-D1, 1930 Zaventem, Belgium. Notice for Radio Equipment Hereby, Sony Visual Products Inc. declares that the radio equipment types FW-85BZ35F, FW-75BZ35F, FW-65BZ35F, FW-55BZ35F, FW-49BZ35F, FW-43BZ35F are in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.compliance.sony.de/ This radio equipment can be operated in the EU without infringing applicable requirements on the use of radio spectrum. Safety Information WARNING Caution Risk of explosion if the battery is replaced by an incorrect type. Batteries must not be exposed to excessive heat such as sunshine, fire or the like or extremely low air pressure that can result in an explosion or leakage of flammable liquid or gas. Stability Hazard The LCD Monitor may fall, causing serious personal injury or death. Never place a LCD Monitor in an unstable location. A LCD Monitor may fall, causing serious personal injury or death. Many injuries, particularly to children, can be avoided by taking simple precautions such as: • Using cabinets or stands recommended by the manufacturer of the LCD Monitor. • Only using furniture that can safely support the LCD Monitor. • Ensuring the LCD Monitor is not overhanging the edge of the supporting furniture. • Not placing the LCD Monitor on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the LCD Monitor to a suitable support. • Not placing the LCD Monitor on cloth or other materials that may be located between the LCD Monitor and supporting furniture. • Educating children about the dangers of climbing on furniture to reach the LCD Monitor or its controls. If your existing LCD Monitor is being retained and relocated, the same considerations as above should be applied. GB Installation/Set-up Install and use the LCD Monitor in accordance with the instructions below in order to avoid any risk of fire, electric shock or damage and/or injuries. Installation • The LCD Monitor should be installed near an easily accessible mains socket. • Place the LCD Monitor on a stable, level surface to prevent it from falling over and causing personal injury or property damage. • Install the LCD Monitor where it cannot be pulled, pushed, or knocked over. • Install the LCD Monitor so that the LCD Monitor's Table-Top Stand does not protrude out from the LCD Monitor stand (not supplied). If the Table-Top Stand protrudes out from the LCD Monitor stand, it may cause LCD Monitor set to topple over, fall down, and cause personal injury or damage to the LCD Monitor. 3GB