Sony HCD-BX50BTi Operating Instructions - Page 16
Pairing this system with a Bluetooth, device, To cancel passkey entry partway - bluetooth pin for
View all Sony HCD-BX50BTi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Pairing this system with a Bluetooth device Pairing is an operation where Bluetooth devices register with each other beforehand. Use the procedure below to pair the system with your Bluetooth device. Once a pairing operation is performed, it does not need to be performed again. If pairing is already completed, proceed to "Playing music of a Bluetooth device" (page 17). 1 Place the Bluetooth device to be connected to this system within 1 meter of the system. 2 Select the Bluetooth function. Press BLUETOOTH on the unit. 3 Operate the Bluetooth device and perform the pairing operation. For details about the operations of the Bluetooth device, refer to the operation manual supplied with your Bluetooth device. When searching for this system with the Bluetooth device, a list of the devices found may appear in the Bluetooth device display depending on the type of Bluetooth device. This system appears as "CMTBX50BTi." When establishing a connection with this system, select the audio profile (A2DP, AVRCP) at the Bluetooth device. If the Bluetooth device does not support the AVRCP profile, you cannot perform playback or other operations with the system (page 17). 4 Enter the passkey. Passkey entry may be required depending on the type of Bluetooth device. When "PIN?" and a countdown appear, enter the passkey at the system as follows: Press / and / on the remote (or +/ and on the unit) to enter the same passkey that was entered at the Bluetooth device, and then press . Once pairing is completed and the connection is established, the system display changes as follows: "Connect" Name of the Bluetooth device To cancel passkey entry partway Press . If passkey entry still required, turn off the Bluetooth device. Notes "Passkey" may be called "Passcode," "PIN code," "PIN number" or "Password," etc. depending on the device. This system only supports numerical passkeys up to 4 digits. The pairing standby status of the system is cancelled after about 30 seconds. If pairing is not successful, redo the procedure from step 1. While connected to a Bluetooth device, this system cannot be detected and a connection cannot be established from another Bluetooth device. 16GB