Sony HCD-BX50BTi Operating Instructions - Page 19
Continued, Pairing this system with Bluetooth, headphones, To cancel passkey entry partway
View all Sony HCD-BX50BTi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Pairing this system with Bluetooth headphones Pairing is an operation where Bluetooth devices register with each other beforehand. Use the procedure below to pair the system with your Bluetooth headphones. Once a pairing operation is performed, it does not need to be performed again. If pairing is already completed, proceed to "Playing music on this system" (page 20). 1 Select a function other than the Bluetooth function. Press FUNCTION +/ (or FUNCTION on the unit) repeatedly. 2 Place the Bluetooth headphones to be connected to this system within 1 meter of the system. 3 Put the Bluetooth headphones in pairing mode. For details about the operations of the Bluetooth headphones, refer to the operation manual supplied with your Bluetooth headphones. 4 Press and hold BLUETOOTH on the unit for about 7 seconds until the BLUETOOTH indicator flashes. Sound output from the speakers is stopped. 5 Enter the passkey. Follow the same procedure as in step 4 of "Pairing this system with a Bluetooth device" (page 16). Once pairing is completed and the connection is established, the system display changes as follows: "Connect" Name of the Bluetooth device Basic Operations To cancel passkey entry partway Press . Notes "Passkey" may be called "Passcode," "PIN code," "PIN number" or "Password," etc. depending on the device. This system only supports numerical passkeys up to 4 digits. The pairing standby status of the system is cancelled after about 30 seconds. If pairing is not successful, redo the procedure from step 1. While connected to a Bluetooth device, this system cannot be detected and a connection cannot be established from another Bluetooth device. Pairing may not be possible if other Bluetooth devices are present around the system. In this case, turn off the other Bluetooth devices. To erase all the pairing registration information 1 Press BLUETOOTH on the unit. When the system is connected with a Bluetooth device (when the Bluetooth device name or other information appears in the system display), press and hold BLUETOOTH on the unit for about 2 seconds to put the system in Bluetooth standby mode. 2 Press CLEAR . "Delete?" appears. 3 Press . "Complete!" appears and all the pairing information is erased. Note To connect with Bluetooth headphones after performing this operation, you must enter the passkey again. Continued 19GB