Sony HDW1800 Installation Manual - Page 30
t take the ME wire off the wire holder.
View all Sony HDW1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
5. Release the lock of the board holder and open the AE31 board in the arrow direction. 6. Check by eye that the unit is in the state to be able to wind manually the tape. 7. Pull the ME wire for a few times with short steps to take up the tape inside the cassette. m . Be careful for the tape not to catch in parts such as a flange of a tape guide. . Don't take the ME wire off the wire holder. . The ME wire links with the T real table. The T real table rotates about 1/24 turns clockwise (takeup direction) by pulling the ME wire about 6 mm. 8. Rotate the M gear of the threading motor block in direction of arrow shown in the EJECT label by about a half turn to slack off the tape. 9. Pull the ME wire for a few times with short steps in the direction of arrow shown in the EJECT label to take up the tape inside the cassette. 10. To wind up the tape into the cassette, repeat steps 8 and 9. n On completely winding up the tape into the cassette, the M gear will be tighten. (Unthreading end state) 11. Check that the ME wire is slacken. 12. Open the lower control panel. 13. Turn the eject knob in the arrow direction of the label until the cassette is completely ejected. Label Eject knob AE-31 board Board holder M gear EJECT label ME wire EJECT label Wire holder Gear box assembly 1-24 (E) HDW-1800/D1800