Sony HT-CT390 Operating Instructions - Page 20
Saving power in standby mode, Mounting the Bar Speaker on a wall - wall mount
View all Sony HT-CT390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
• Sound may be interrupted when the sampling frequency or the number of channels of audio output signals from the playback equipment is switched. • If the connected equipment is not compatible with copyright-protection technology (HDCP), the image and/or the sound from the HDMI OUT jack of this system may be distorted or may not be output. In such a case, check the specifications of the connected equipment. Saving power in standby mode Check that you have made the following settings: - "CTRL" in "HDMI>" is set to "OFF" (page 17). - "BTSTB" in "BT >" is set to "OFF" (page 17). • Sony shall not be held responsible for accidents or damage caused by improper installation, insufficient wall strength, improper screw installation or natural calamity, etc. 1 Fix the supplied wall mounting brackets to the bracket fixing holes on the bottom of the Bar Speaker with the supplied screws so that the surface of each wall mounting bracket is as shown in the illustration. Fix the two wall mounting brackets to the left and right fixing holes on the bottom of the Bar Speaker. Screw (supplied) Wall mounting bracket (supplied) Mounting the Bar Speaker on a wall You can mount the Bar Speaker on a wall. Notes • Prepare screws (not supplied) that are suitable for the wall material and strength. As a plasterboard wall is especially fragile, attach the screws securely to two studs in the wall beam. Install the Bar Speaker horizontally, hung by screws in studs in a continuous flat section of the wall. • Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety during the installation. 20US