Sony KLV-S32A10 Instructions (SU-WL31 Wall-Mount Bracket) - Page 10

3 Adjust the angle of the stabilizer arms. When installing the TV perpendicularly (0 degrees), adjustment of the arms angle (step 1 and 2 below) is not necessary. Make sure that each stabilizer arm is screwed in securely. 1 Remove all four angle adjust screws. 2 Put them into the screw holes corresponding to the desired angle (5, 10, 15 or 20 degrees) and tighten them firmly. Notes • Be sure to adjust the angles of the right and left arms to the same angle. • Be careful not to pinch your fingers when adjusting the angle of arms. • When using an electric screwdriver, set the torque setting to approximately 2 N·m {20 Kgf·cm}. • Make sure that four arm bases are screwed in securely. Notes on the adjustment angles • When installing TV or monitor models other than those specified on page 2 (depending on the model's size and dimensions, etc.), the adjustment angles listed (0, 5, 10, 15, 20 degrees) for the stabilizer arms may be limited. • For the available adjustment angles of the stabilizer arms when installing TV or monitor models other than those specified on page 2, refer to the operating instructions or the leaflet ("Installing the Wall-Mount Bracket") supplied with the TV or monitor. Stabilizer arm Step 5: Preparing for the installation of the TV The procedure differs depending on the TV. Apply the procedure appropriate for the TV you are installing. KDL-V32A1s*/KLV-V32A1s*/ KDL-V32XBR1 A KDL-V26A1s*/KLV-V26A1s*/ KDL-V26XBR1 B KDL-S32A1s*/KLV-S32A1s C KDL-S26A1s*/KLV-S26A1s D KDL-S23A1s*/KLV-S23A1s E * In the actual model names, the "s" indicates numbers and/or characters specific to each model. 1 Detach the Table-Top Stand from the TV. 1 Place the TV, with its screen facing down, on a stable, cloth-covered work surface. ABCDE 1 Angle adjust screw Arm Bases A and B Soft cloth 2 10 (GB)