Sony MEX-R1 Operating Instructions - Page 39
Switching the front/rear output, - Zone × Zone, Additional Information, Maintenance, output
View all Sony MEX-R1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Switching the front/rear output - Zone × Zone You can set to have DVD audio/video output to the rear monitor, and output another source to the front. This function is convenient when you want to enjoy radio, music playback, etc, in the front, and DVD playback in the rear. Z × Z ATT DVD OFF SRC MODE TOP MENU + SOUND SETUP SYSTEM LIST ENTER - MENU PICTURE Z × Z EQ DSO AUDIO SUBTITLE ANGLE MENU EQ7 1 Press (ZxZ). 2 Press (SOURCE) on the main unit to switch the source of the front. Operate the front with the main unit, and the rear (DVD) with the card remote commander. To return to normal status Press (ZxZ). Notes • While Zone × Zone is activated, the following buttons on the card remote commander become inactive: (ATT), (SRC) (SOURCE), (MODE), (VOL) +/-, (SYSTEM MENU), (LIST), (SOUND), (DSO), (EQ7). • Zone × Zone is not cancelled even if the disc is ejected, and it will be activated when a disc is inserted again. Additional Information Maintenance Replacing the lithium battery of the card remote commander Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion. + side up 2c 1 Notes on the lithium battery • Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. • Wipe the battery with a dry cloth to assure a good contact. • Be sure to observe the correct polarity when installing the battery. • Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire. Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Fuse (10A) continue to next page t 39