Sony RM-VL710 Operating Instructions - Page 31

Copying the settings of a Component Select button to another button You can copy the entire settings of a Component Select button to another Component Select button. The settings of the component code (page 8) and the "learned" function (page 14) are copied to a new button. 1 SET POWER TV VCR CBL DVD AMP 2 1 23 4 56 7 89 0 ENT 2 Press and hold for over 3 seconds the desired Component Select button to which you want to copy a setting from another component. While holding down this button, the other Component Select buttons flash. Then, when you press the Component Select button which holds the setting you want to copy, all Component Select buttons light up. When copying is complete, any Component Select buttons other than the two buttons pressed, turn off. TV VCR CBL DVD AMP for over 3 seconds TV VCR CBL DVD AMP 1 TV VCR CBL DVD AMP TV VCR CBL DVD AMP Example: To copy the settings of the DVD button to the CBL button 1 Press and while holding SET, press MENU. All Component Select buttons flash. TV VCR CBL DVD AMP To cancel setting, press SET. Notes • You cannot copy the settings to a Component Select button on which any "learned" function (page 14) has been programmed. • Since you can only operate a TV using the TV Component Select button, and you cannot copy other Component Select button settings (other than for a TV) to the TV Component Select button. • You cannot copy the Control Program function (Component Macro) to another Component Select button. To return the setting of the Component Select button to the original component setting Clear the "learned" function (page 20) and perform the original component setting following the procedure on page 31. 31