Sony STR DG810 Instruction manual - Page 28

Inserting batteries into the remote Insert two R6 (size-AA) batteries in the RM-AAP016 remote commander. Observe the correct polarity when installing batteries. Notes • Do not leave the remote in an extremely hot or humid place. • Do not use a new battery with old ones. • Do not mix alkaline batteries and other kinds of batteries. • Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction. • If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. • When you replace the batteries, the remote buttons may be reset to their factory settings. If this happens, reassign the buttons again (page 79). Tip Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all the batteries with new ones. 6: Selecting the speaker system You can select the front speakers you want to drive. Be sure to use the buttons on the receiver for this operation. SPEAKERS (OFF/A/B/A+B) ?/1 SPEAKERS (OFF/A/B/A+B) TONE MODE TONE TUNING MODE TUNING AUTO CAL MIC PHONES VIDEO 3 IN/PORTABLE AV IN VIDEO L AUDIO R DISPLAY INPUT MODE INPUT SELECTOR MASTER VOLUME MEMORY/ CATEGORY ENTER MODE CATEGORY 2CH A.F.D. MOVIE MUSIC AUTO CAL DIRECT Press SPEAKERS (OFF/A/B/A+B) repeatedly to select the front speaker system you want to drive. To select Light up The speakers connected to the SPEAKERS FRONT A terminals The speakers connected to the SPEAKERS FRONT B terminals The speakers connected to both the SPEAKERS FRONT A and B terminals (parallel connection) SP A SP B SP A and SP B To turn off the speaker output, press SPEAKERS (OFF/A/B/A+B) repeatedly until the "SP A" and "SP B" indicators on the display do not light up. 28US