Sony STR DG810 Instruction manual - Page 91

Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U, CA1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 100 W + 100 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 110 W + 110 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 150 W/ch 1)Measured under the following conditions: Area code Power requirements U, CA 120 V AC, 60 Hz 2)Reference power output for front, center, surround and surround back speakers. Depending on the sound field settings and the source, there may be no sound output. Frequency response Analog 10 Hz - 70 kHz, +0.5/-2 dB (with sound field and equalizer bypassed) Input Analog Digital (Coaxial) Digital (Optical) Output (analog) AUDIO OUT SUB WOOFER Equalizer Gain levels Sensitivity: 500 mV/ 50 kohms S/N3): 96 dB (A, 500 mV4)) Impedance: 75 ohms S/N: 100 dB (A, 20 kHz LPF) S/N: 100 dB (A, 20 kHz LPF) Voltage: 500 mV/10 kohms Voltage: 2 V/1 kohm ±10 dB, 1 dB step 3)INPUT SHORT (with sound field and equalizer bypassed). 4)Weighted network, input level. FM tuner section Tuning range 87.5 - 108.0 MHz Antenna FM wire antenna Antenna terminals 75 ohms, unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range Area Tuning scale code U, CA 10 kHz step 9 kHz step 530 - 1,710 kHz 5) 531 - 1,710 kHz 5) Antenna Loop antenna Intermediate frequency 450 kHz 5)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure. Additional Information continued 91US