Sony TC-WE475 Operating Instructions (primary manual) - Page 7

Playing a Tape Playing a Tape Playing a tape 1 Turn on the amplifier and select the tape deck position. 2 Press POWER, and press A fully to open the cassette holder, then load a cassette. With the side you want to play facing you Tips • Push in PITCH CONTROL to activate the Pitch Control function and turn the control clockwise to raise the pitch or counterclockwise to lower it. You can adjust the pitch during playback on deck A or normal-speed dubbing (but not during RMS play 2) or RMS dubbing 2)). 2) TC-WE675 only • To play a tape recorded with the Dolby 3) NR, set DOLBY NR to ON (TC-WE675 only) and select the same position that the tape was recorded in-B or C. 3) "Dolby", "HX Pro", and the double-D symbol are trademarks of Dolby Laboratories. 3 Set DIRECTION MODE. To play back Set to One side only g Both sides continuously 1) s Both decks in succession 1) RELAY 1) The deck automatically stops after playing back five times. 4 Press H. The deck starts playing. Adjust the volume on the amplifier. Do not press POWER or A while the tape deck is operating. If you do so, the tape may be damaged. To Press Stop playing x Start playback from the h reverse side Pause X PAUSE. Press the button again to resume play. Fast-forward or rewind M or m when the deck is stopped Take out the cassette A after stopping playing 7