Sony VPL EX5 User Manual - Page 47
Messages List, Remote Commander, Others, Indicators, Warning Messages
UPC - 027242737334
View all Sony VPL EX5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Remote Commander Symptom Cause and Remedy The Remote Commander The Remote Commander battery are dead. does not work. c Replace them with new battery (see page 16). Others Symptom The control panel keys do not function. Cause and Remedy The control panel keys are locked. c Unlock the control panel keys (see page 36). Indicators Symptom Cause and Remedy The LAMP/COVER • The lamp cover or the air filter cover is detached. indicator flashes in orange. c Attach the cover securely (see pages 43 and 44). (Repetition rate of 2 flashes) The LAMP/COVER indicator flashes in orange. (Repetition rate of 3 flashes) • The lamp has reached the end of its life. c Replace the lamp (see page 42). • The lamp has reached a high temperature. c Wait for 60 seconds to cool the lamp and then turn on the power again. :/1 key flashes in red. (Repetition rate of 2 flashes) • The internal temperature is unusually high. c Check to see that nothing is blocking the ventilation holes. • The projector is being used at a high altitude. c Ensure that "High Altitude Mode" in the Setup menu is set to "On." :/1 key flashes in red. (Repetition rate of 4 flashes) The fan is broken. c Consult with qualified Sony personnel. :/1 key flashes in red. (Repetition rate of 6 flashes) Unplug the AC power cord from the wall outlet after the :/1 key stops flashing, plug the power cord to the wall outlet, and then turn the projector on again. If the ON/STANDBY flashes in red and the problem persists, the electrical system has failed. c Consult with qualified Sony personnel. Others Messages List Warning Messages Use the list below to check the meaning of the messages displayed on the screen. Message Meaning and Remedy Please replace the Lamp and clean the Filter. • It is time to replace the lamp and clean the air filter. c Replace the lamp (see page 42) and clean the filter (see page 44). • When this message appears even after replacing the lamp, the task has not been completed. c Perform the operation of steps 10 to 13 on page 43 Troubleshooting 47