Symphonic SC1303 Owner's Manual - Page 9
Preparation For Use
View all Symphonic SC1303 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PREPARATION FOR USE ANTENNA/CABLE CONNECTIONS From Cable System or Satellite Dish Satellite Box or Cable Box OUT IN (Not supplied) Rod Antenna (Supplied with 13" model only) VHF/UHF Antenna (Not supplied) VHF Antenna (Not supplied) From Cable System UHF Antenna or (Not supplied) ANT. 75-ohm Coaxial or ANT. Cable (Not supplied) VHF/UHF or Combiner (Not supplied) or Flat twin-lead cable VHF/UHF COMBINED ANTENNA The VHF/UHF Rod Antenna (supplied with 13" model only) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/VCR. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/VCR as shown in the diagram above. For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.) NOTE: Before plugging the Rod antenna into antenna terminal, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into antenna terminal. Bent pin Cable Plug (Needs to be straightened) (Straight pin) NOTE: The connection of an indoor antenna may not always give acceptable TV reception. VHF/UHF SEPARATE ANTENNAS In some areas it will be necessary to use an outdoor antenna. CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can: 1) Use the TV/VCR remote to select channels. 2) Program one or more unscrambled channels for Automatic Timer Recording. NOTE: This unit will ONLY record and view the same channel. CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here. By using this connection you can also record scrambled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer recording is limited to one channel at a time. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. -9- EN 9I03