Symphonic TVCR19G1 Owner's Manual - Page 23
Record/otr
View all Symphonic TVCR19G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
OTR (One Touch Recording) This function enables you to set a recording length simply by pressing RECORD/OTR button on the TVNCR. Make sure ... • Power must be turned on. • Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.) NOTE:This function cannot be done by the remote control. COPYING A VIDEO CASSETTE (Re uires another VCR) You can make copies of video tapes made by friends or relatives for your enjoyment. WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. Connect your TVNCR and a Source (Playing) VCR using the following diagram. 1 Select the channel to be recorded Press the number buttons on the remote control or the CHANNEL V or A button. [The TVNCR] 2 Begin OTR OTF1(2 30) Press RECORD/OTR button on the TVNCR as many times as needed. The recording length will be determined by the number of times you press RECORD/OTR button. Each additional push will increase the recording time by 30 minutes. It is set up to 8 hours. Push(es) 1 push 2 pushes 3 pushes .1, 17 pushes Display Recording length (normal recording) 0:30 30 minutes 1:00 I 60 minutes 1 I 8:00 480 minutes HINTS: • Recording starts immediately when the REC/OTR button is pressed. • When REC/OTR button is pressed 18 times, the TV/VCR will switch to the Normal Recording mode. • To stop the OTR operation, press STOP button on the TVNCR or on the remote control. • To show the remaining time, press DISPLAY button repeatedly until "OTR" appears on the TV screen. • Recording stops when 0:00 is reached. • Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the TVNCR will switch to the Stop mode immediately, eject the tape and the TVNCR power will be turned off. , , ,0 Ver0 O a AudioNideo adapter cord (not supplied) To Video/Audio output VIDEO 0' OUT pi @ AUDIO [Ex: Source (Playing) VCR] 1) Insert a pre-recorded video cassette into the Source (Playing) VCR. 2) Insert a blank video cassette, or one you want to record over, into the TVNCR's cassette compartment. 3) Press SPEED button to select the desired recording speed (SP, LP or SLP). 4) Press CHANNEL A or V button repeatedly so that "AUX" appears on the screen. 5) Begin playback of the tape in the Source (Playing) VCR. 6) Press RECORD button on the TVNCR. NOTE: For best results during dubbing, use the TVNCR's front panel controls whenever possible. The remote control might affect the Source (Playing) VCR's playback operation. - 23 - EN 6K27