TEAC CD-RW900SL CD-RW900SL Owner's Manual - Page 9

IMPORTANT SAFETY1 −INISnTtRroUdCuTIcOtiNoSn Beware of condensation If the unit (or a compact disc) is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation; vapor in the air could condense on the internal mechanism, making correct oper- Use of the remote control unit • Do not expose the infra-red receiver (light receptive area on the front panel) to direct sunlight or intense light for extended periods of time. Long exposure to this light may result in failure of the remote control sensor. • When the remote control will not be used over one month, please remove the batteries to prevent the possibility of battery acid leakage which could damage the unit. Should leakage occur, remove and discard the batteries, and wipe the battery case thoroughly with a cloth. Avoid getting the battery liquid on the skin. After cleaning, replace with new batteries. Batteries If batteries are used improperly, or if leakage or breakage occurs, the unit will not function. Please observe the cautions indicated on the batteries and their packaging to ensure proper usage. • Confirm + and - polarity and follow the indications when inserting new batteries into the remote control. • Do not use old and new batteries together. • Even if the battery is the same size, the voltage may differ. Do not use batteries of different specifications together. • Do not attempt to recharge batteries that are non-rechargeable. • Do not open or disassemble batteries, throw them into a fire or put them in water. Connections The following should be noted when you connect the unit to other equipment. It is possible to connect the unit's DIGITAL COAXIAL IN, DIGITAL OPTICAL IN and ANALOG UNBALANCED INs (L, R) to other equipment at the same time. However, the unit can receive signals from only one digital input at a time. Currently selected input jack is shown on the display. ation impossible. To prevent this, or if this occurs, let the player sit for one or two hours at the new room temperature before using. • The remote control functions by using an infrared light signal. When using the unit to control the CD-RW900SL, other devices that are turned on could be operated by its signal. • If the range of remote operation becomes smaller, or commands do not always function properly, the batteries have become weak and should be replaced. Always replace both batteries with new batteries of the same type. • Point the remote control to the remote sensor on the main unit. Do not obstruct the path between the remote control and the remote sensor. ª Inserting batteries 1. Open the lid. 2. Confirm +/- polarity, and insert two AAA batteries. 3. Close the lid. Audio signals output from the unit are output from the analog ANALOG OUT jacks, as well as from the DIGITAL COAXIAL OUT jack and DIGITAL OPTICAL OUT connector simultaneously (but not from the digital outputs in stop mode).  TASCAM CD-RW900SL