TEAC W-890RmkII-B Manual for W-890R - Page 15
To erase recordings, Quick record start, Recording silence, To stop recording temporarily
View all TEAC W-890RmkII-B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH 8 When everything is ready, start recording by pressing the PAUSE key or the PLAY key whose arrow points in the same direction as the indicator. Recording silence When you press the REC MUTE key during recording, the unit records no signal for about 4 seconds and then enters the record-pause mode. To resume recording, press the PAUSE key. To record on both tape sides, set the REV MODE switch to j or p and press the forward PLAY (y) key. If you press the reverse PLAY (h) key, recording will be done only on side "B". To stop recording, press the STOP (H) key. A To stop recording temporarily Press the PAUSE key to stop recording temporarily. A second press of the key resumes recording. To erase recordings When you make a recording, the tape is overwritten (previous recording is erased). To erase a tape without making a new recording, set the REC LEVEL control to the minimum (0) position and press the RECORD (K) key followed by the PLAY (h or y) key. < To create a blank of more than 4 seconds long Hold down the REC MUTE key for the desired length of time. When you release the key, the deck enters the record-pause mode. < To create a blank of less than 4 seconds long Press the PAUSE key within 3 seconds of pressing the REC MUTE key. NOTE If you press the REC MUTE key when the deck is in the recordpause mode, no signal is recorded for about 4 seconds, and then the deck shifts back to the record-pause mode. Quick record start Press the RECORD (K) key and press the PLAY (h or y) key corresponding to the direction you want the tape to run. 15