TP-Link T1600G-18TSTL-SG2216 T1600G-18TSUN V1 Configuration Guide - Page 425

Configuring Static Routing Example for Static Routing with the mode as static, the IP address as 10.1.10.1, the mask as 255.255.255.0 and the admin status as Enable. Switch_A#configure Switch_A(config)#interface gigabitEthernet 1/0/1 Switch_A(config-if)#no switchport Switch_A(config-if)#ip address 10.1.1.1 255.255.255.0 Switch_A(config-if)#exit Switch_A(config)#interface gigabitEthernet 1/0/2 Switch_A(config-if)#no switchport Switch_A(config-if)#ip address 10.1.10.1 255.255.255.0 2) Add a static route entry with the destination as 10.1.2.0, the subnet mask as 255.255.255.0 and the next hop as 10.1.10.2. For switch B, add a static route entry with the destination as 10.1.1.0, the subnet mask as 255.255.255.0 and the next hop as 10.1.10.1. Switch_A#configure Switch_A(config)#ip route 10.1.2.0 255.255.255.0 10.1.10.2 Switch_A(config)#end Switch_A#copy running-config startup-config Verify the Configurations  Switch A Verify the static routing configuration: Switch_A#show ip route Codes: C - connected, S - static * - candidate default C 10.1.1.0/24 is directly connected, Vlan10 C 10.1.10.0/24 is directly connected, Vlan20 S 10.1.2.0/24 [1/0] via 10.1.10.2, Vlan20  Switch B Verify the static routing configuration: Switch_B#show ip route Codes: C - connected, S - static Configuration Guide 402