TP-Link T1600G-18TSTL-SG2216 T1600G-18TSUN V1 Configuration Guide - Page 549
Configuring the IPv6 ACL, Enter an ACL ID. The ID ranges from 3500 to 4999.
View all TP-Link T1600G-18TSTL-SG2216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 549 highlights
Configuring ACL ACL Configurations Configuring the IPv6 ACL Step 1 configure Enter global configuration mode Step 2 access-list combined access-list-num Create an IPv6 ACL. access-list-num: Enter an ACL ID. The ID ranges from 3500 to 4999. Step 3 access-list ipv6 acl-id rule rule-id {permit | deny}[dscp dscp-value] [flow-label flow-labelvalue] [sip source-ip-address sip-mask source-ip-mask] [dip destination-ip-address dip-mask destination-ip-mask] [s-port source-port-number] [d-port destination-port-number] Add a rule to the ACL. acl-id: The ID number of the ACL you have created. rule-id: Specify the rule ID, which ranges from 0 to 999. It should not be the same as any existing IPv6 ACL IDs permit|deny: Specify the operation to be performed with the packets that match the rule. Deny means to discard; permit means to forward. By default, it is permit. dscp-value: Specify a DSCP value to be matched. flow-label-value: Specify a Flow Label value to be matched. source-ip-address: Enter the source IP address. Enter the destination IPv6 address to be matched. All types of IPv6 address will be checked. You may enter a complete 128-bit IPv6 address but only the first 64 bits will be valid. source-ip-mask: Enter the source IP address mask. The mask is required if the source IPv6 address is entered. Enter the mask in complete format (for example, ffff:ffff:0000:ffff). The mask specifies which bits in the source IPv6 address to match the rule. destination-ip-address: Enter the destination IPv6 address to be matched. All types of IPv6 address will be checked. You may enter a complete 128-bit IPv6 addresses but only the first 64 bits will be valid. destination-ip-mask: Enter the source IP address mask. The mask is required if the source IPv6 address is entered. Enter the mask in complete format (for example, ffff:ffff:0000:ffff). The mask specifies which bits in the source IPv6 address to match the rule. source-port-number: Enter the TCP/UDP source port if TCP/UDP protocol is selected. destination-port-number: Enter the TCP/UDP destination port if TCP/UDP protocol is selected. Step 4 show access-list [access-list-num] (Optional) View the current ACL configuration. access-list-num: The ID number of the ACL. Step 5 end Return to privileged EXEC mode. Configuration Guide 526