Thermador HMWN30FS Installation Instructions - Page 11
Thermador HMWN30FS Manual
 |
View all Thermador HMWN30FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Wiring the HOOD with an Integral Ventilator: Warning: Turn off electricity at the service panel before wiring the unit. 1. Connect the Integral Ventilator molex plug connector to the connector present inside the hood as shown in Figure 6. 2. Remove the j-box cover as shown in Figure 7. 3. Remove 1 of 2 knockouts and install 1/2" conduit connector in j-box. 4. Run black, white, and green wires (#14 AWG) in 1/2"conduit from power supply to j-box. 5. Connect black, white, and green wires from power supply to black, white, and green/ yellow wires in j-box respectively. 6. Close j-box coover. 7. Turn power on at service panel. Check operation of the hood. Power supply conduit Figure 7 Motor Connector Figure 6 11
-
1 -
2
-
3
-
4
-
5
-
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
 |
 |
11
Wiring the HOOD with an
Integral Ventilator:
Figure 7
Motor Connector
Warning:
Turn off electricity at
the service panel before wiring the
unit.
1.
Connect the Integral
Ventilator
molex plug connector to the
connector
present
inside the
hood as shown in
Figure 6.
2.
Remove
the
j-box cover
as
shown in Figure 7.
3.
Remove 1 of 2 knockouts and
install 1/2” conduit
connector
in j-box.
4.
Run black, white, and green
wires (#14 AWG) in 1/2”conduit
from power supply to j-box.
5.
Connect black, white, and
green wires from power supply
to black, white, and green/
yellow wires in j-box
respectively.
6.
Close j-box coover.
7.
Turn power on at service
panel.
Check operation of the hood.
Power supply conduit
Figure 6