Thermador HMWN30FS Installation Instructions - Page 6

Examples of possible ducting

Page 6 highlights

t Typical installation The height from the countertop to the bottom of the hood is 30" to 36". These hoods are not recommended to be used over indoor grills. 1. Choose vent options The hood is designed to be used for vertical discharge as shown below. Note: see also Fig. 1-2-3 for Cabinet preparation. Install a 1/2" conduit from the service panel long enough to reach the hood once it is installed. Power supply must be rated for 120 VAC, 60Hz. 15 or 20 A. Ceiling *Deflector Lam p Hood 30" to 36" Examples of possible ducting Round duct Transition Blower *Charcoal filters Filter Ceiling Lam p Hood * Charcoal filters 30" to 36" Transition Blower Filter RECIRCULATING * Optional accessory - Ductless recirculation kit * Only for 30" and 36" using integral blower VTN600F VERTICAL DISCHARGE 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

30” to 36”
* Charcoal filters
Lam p
Round duct
Ceiling
Hood
Blower
Transition
Filter
VERTICAL DISCHARGE
30” to 36”
* Optional accessory - Ductless recirculation kit
* Only for 30” and 36” using integral blower VTN600F
Lam p
Ceiling
Hood
Blower
Transition
Filter
*Deflector
RECIRCULATING
*Charcoal filters
Examples of possible ducting
6
Typical installation
The height from the countertop to the bottom of the hood is 30” to 36”.
These hoods are not recommended to be used over indoor grills.
1.
Choose vent options
The hood is designed
to be used for vertical discharge as shown below.
Note:
see also Fig. 1-2-3 for Cabinet preparation.
Install a 1/2” conduit from the service panel long enough to reach the hood
once it is installed. Power supply must be rated for 120 VAC, 60Hz. 15 or 20 A.