Toshiba MW27FP1 Owners Manual - Page 40
Timer recording
View all Toshiba MW27FP1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Recording (VCR) Timer recording Timer recording can be programmed on-screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programs within 1 month. TV/VCR TIMER REC MENU ENTER Timer recording Preparation: • Press TV/VCR to select the TV/VCR mode. • Load a cassette tape with the erase prevention tab intact. • Check the time and date are correct 21 . Example: Program a timer recording for 23rd day, channel 125 (Cable TV), 7:00 - 9:30 PM (Tape speed : SLP). 1 Press MENU, then press option. or to select MENU SETUP ENTER TIMER REC SET AUTO REPEAT OFF / / / / MENU 2 Press or to select "TIMER REC SET", then press . ENTER TIMER REC SET AUTO REPEAT OFF / / / MENU 3 Press or to select one of the program line, then press ENTER. 5 Set the start time, end time, channel and tape speed as in step 4. Then press ENTER. ENTER TIMER REC SET DATE 2 3(THU) START 7:0 0PM END 9:3 0PM CH 125 SPEED SLP / / / / ENTER/MENU Notes: • Press to move cursor backward for correction. • To record from external source set the channel to "L1" or "L2". 23 TH 7:00PM 9:30PM 125 SLP / / ENTER/CANCEL/MENU 6 To set the timer for another program, repeat steps 3 to 5 to set another program. 7 Press both TIMER REC at the same time. The TIMER REC indicator will light. The Timer is programed, when the programed time is reached, the recording is automatically started. TIMER REC To cancel timer recording, press TIMER REC both the buttons again and TIMER REC indicator will go out. Notes: • The VCR section cannot be used while the TIMER REC in- ENTER dicator is lit. If you want to use the VCR operation,press both TIMER REC buttons at the same time to deactivate the timer. • When the clock is not set, you cannot select "TIMER REC". In this case, set the clock (see pages 19~21). 4 Press or to select the date, then press . • After a power failure or disconnection of the power plug,all programmed recording setting and time display will be lost upon resumption of power. In this case, reset the clock (see pages 19~21) and reprogram any timer recordings. TIMER REC SET • If you want to correct the digits while setting, press or DATE 2 3(THU) ENTER START END 8:3 0AM Ð Ð:Ð Ð until the item you want to correct, then press or to CH 012 correct the desired setting. SPEED SP • If programming is performed without a tape in the unit, or / / / / MENU with a tape without an erase prevention tab, the Timer Re- cording is not possible. If a tape without an erase prevention tab is in the unit, the tape will be ejected. 40 5L00201C [E]p38-41 40 20/4/04, 16:07