Toshiba Tecra A2-S20ST Maintenance Manual - Page 114
Enter, H/W initial information setting tool, ERROR STOP
View all Toshiba Tecra A2-S20ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test Use the up and down arrow keys to move the cursor to "ERROR STOP". Use the right and left arrow keys to move the cursor to the desired option and press Enter. Selecting YES of ERROR STOP stops the test program when an error is found and displays the operation guide on the right side of the display screen as shown below: ERROR STATUS NAME [[ HALT OPERATION ]] 1: Test end 2: Continue 3: Retry These three selections have the following functions respectively: 1. Terminates the test program and exits to the subtest menu. 2. Continues the test. 3. Restarts the test from the error. Selecting NO keeps the test running even if an error is found. When an error occurred, the error status is displayed and the error counter is increased by one. Table 3-1 in section 3.4 describes the function of each test on the subtest menu. Table 3-2 in section 3.21 describes the error codes and error status for each error. 3.2.2 H/W initial information setting tool The following menu appears in the display. ########## H/W initial information setting tool VX.XX ####### ## # * 1 Initial configuration * * 2 Region write * * 8 System configuration display * * 9 E2PROM test (MAC/DMI) * * ... Press test number[1,2,8,9] ? For more details on this test, refer to the section 3.3. 3-6 Satellite A50/TECRA A2 Maintenance Manual (960-478)