Toshiba W708 Owners Manual - Page 33
ENTER, TIMER, Confirming the VCR Plus, system, timer programs, Recording or playback in the timer
View all Toshiba W708 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
RECORDING 5 Press ENTER. The program setting is now memorized. PROGRAM SET UP PRESET CH DATE On OFF SPD 25 8 / 30 9 : 30PM 10 : 00PMSLP EnD: PROG 6 To set another program, repeat steps 1 to 5. 7 To finish press the two TIMER buttons simultaneously. The VCR enters the timer standby mode. REC POWER TIMER TIMER Confirming the VCR Plus+® system timer programs Before the VCR enters the timer standby mode (TIMER indicator not lit) 1) Press PROG. to display the MENU screen. 2) Press ENTER to select "PROGRAM". Check the programmed data. 3) Press PROG. to exit. During the timer standby mode (TIMER indicator lit) Press PROG.. The screen for confirming appears. After about 30 seconds, the screen disappears. Canceling the VCR Plus+® system timer programs 1) If the TIMER indicator is lit, press both TIMER to turn it off, and turn on the VCR by pressing POWER. 2) Press PROG. to display the MENU screen. 3) Press ENTER to select "PROGRAM". 4) Select a program which you want to cancel. 5) Press CANCEL. The line is cleared out. 6) Press PROG. to exit. Recording or playback in the timer standby mode First press both TIMER to release the timer standby mode, and then press POWER to turn on the VCR. The VCR will be available for use. • Be sure to press both TIMER again to return the VCR to the timer standby mode after you have finished. Error indications If "FULL / CANCEL PROG?" message appears on the TV during programming, no more programs can be entered. If you want to add another, delete one existing program on the screen by using PLAY/x2 or STOP. If an incorrect PlusCode® programming number is entered, "ERROR CODE ENTERED" appears on the screen. Press CANCEL to clear the number and enter correct one. If "CLASH" message appears on the TV during programming, it tells you that two programs with the same recording start time have been entered. Correct either of the two programs as follows: 1) Select the number of the program to correct by using PLAY/x2 or STOP. 2) Correct the data, or clear out the line by pressing CANCEL and then press VCR Plus+ to enter a PlusCode® programming number. 33