Tripp Lite 5PXEBM72RTG2 Owners Manual for 5PX1000RTG2 5PX1000RTNG2 5PX1500RTG2 - Page 24
Communication ports, DB9-8]: [On bat] [Low bat] [Bat fault] [UPS OK] [Load
View all Tripp Lite 5PXEBM72RTG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Submenu Available settings [DB9-7]: [On bat] [Low bat] [Bat fault] [UPS OK] [Load protected] [Load powered] [General alarm] [OVL prealarm] [DB9-8]: [On bat] [Low bat] [Bat fault] [UPS OK] [Load protected] [Load powered] [General alarm] [OVL prealarm] Default settings Remote command [Yes] [No] If Enabled, shutdown or restart commands from software are authorized. [Yes] Shutdown commands [Send CMD] [Output OFF] [OFF delay] [restart] Sets events or fault that will actuate Output signal parameters through external contact connector or RS232 port [Send CMD]: [Yes] [No] [Output OFF]: [No] [UPS] [Group 1] [Group 2] [Group 1 + 2] [OFF delay]: [0s] ...[999s] [Restart]: [Yes] [No] For a proper server shutdown please make sure that the Output OFF delay is long enough Send CMD: [No] Output OFF: [No] OFF delay: [0s] Restart: [Yes] On battery notice delay [0s] ... [99s] Sets delay before providing an on battery notice to software. [0s] General alarm [On battery] [Battery fault] [Overload pre-alarm] [Internal fault] [Ambient temp.] [Fan lock] [Current limit] [Short circuit] [Inverter overload] [Power overload] [Low battery] [UPS OK] [Load protected] [Load powered] Defines which event or fault will generate a general alarm through Output signal screen. [Internal fault] Set Comm Card IPv4 [DHCP] : [Yes] [No] [IP Adress] [Subnet mask] [Gateway] The UPS does not display the IPv4 settings menu by default, you can activate it by a communication command. [Yes] XXX.XXX.XXX.XXX 4.5 Communication ports 614-40095-00 24