Uniden 1060-2 English Owners Manual - Page 13

Using your phone Make a call 1 Press the symbol is displayed. When you hear the dial tone, dial the number you want. The number is shown in the display. After a short delay the call timer will start timing the call. 2 Press to exit and return to standby. Adjust the earpiece/speaker volume during a call 1 Press or to adjust the volume. There are six levels. Make a call by pre-dialing 1 In standby, enter the number to be dialed. The number is displayed. You can enter numbers up to 24 digits long. Press to delete any incorrect digits. Press and hold to delete all digits. 2 Press to dial the displayed number. Handset range If the handset is too far away from the base, during standby, Searching appears and the symbol will flash. During a call you will hear a warning tone. You will need to mover closer to the base for clearer reception and to avoid being disconnected. Call timer When you make or receive a call, a short while after the line is connected the call timer will show the duration of the call in the display in hours, minutes and seconds. The call time will be displayed for a further 5 seconds after you end the call. Handsfree You can use handsfree to talk to your caller without holding the handset to your ear. You can speak into the handset microphone and listen over the loudspeaker. Handsfree also enables other people in the room to listen in to the conversation. [12]