Uniden DC10QG Owners Manual - Page 13
Powering Up The Dc10qg
View all Uniden DC10QG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
POWERING UP THE DC10QG Only use the DC car adapter that comes with your device. Any other adapter might damage the device. 1. Refer to your car's owner's manual to verify where the power outlets are on and around the dashboard. Locate an outlet that supplies 12V electric power when the key is in the ON or ACC position. 2. Connect the car adapter to the camera through the miniUSB port and to the 12V power outlet. 3. Start the car. The camera turns on automatically and begins recording. When the car's engine is turned off, the camera will automatically turn off in a few seconds. Charge the camera for at least 15 minutes after it is turned on for the first time or after it has been turned off for more than three weeks. 4. At other times, press the button to turn it on. Press and hold the button to turn it off. The camera charges the battery whenever power is detected through the miniUSB port. When the camera is being charged, the blue LED glows. It will automatically turn red when the camera has been charged completely. The camera takes about 120 minutes to charge completely from an empty state; the blue LED will then 13