ViewSonic PF775 User Manual - Page 7

Quick Installation 1 Connect video cable Make sure both the monitor and the computer are powered OFF. Connect the video cable to the computer. Macintosh® users: Connect a Macintosh adapter to the video cable, then to the computer. To order a Macintosh adapter, send an email to [email protected] or call ViewSonic® Customer Service (see the back cover of this guide). You will need to provide your monitor's serial number. 5 Windows users: Setting the Timing Mode (resolution and refresh rate) Example: 1024x768@ 75Hz. For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card. 6 Use the OnView® controls to E N G L I S H adjust the screen image. See the Operations section in this guide. 2 Connect power cord Connect the power cord to a properly grounded AC outlet, then to the monitor. 3 Power-ON monitor and computer Power-ON the monitor, then power-ON the computer. This sequence (monitor before computer) is very important. NOTE: At this point Windows® 98 users may receive a message asking them to install the PF775's INF file. Installation is complete! Enjoy your new PF775 Monitor! To be best prepared for any future customer service needs: • Write the serial number (see back of the monitor) in "For your Records" on page 1 of this guide. • Register the warranty of your monitor on the Internet at: http://www.viewsonic.com 4 Install INF and ICM files • For CD-ROM: Insert the CD-ROM into your system, wait for it to autostart, select "Monitor Drivers," and follow the on-screen instructions. • For diskette: Insert the diskette into your system, run install.exe, and follow the on-screen instructions. Monitor Video port (D-sub) Power cord Computer Video cable 6 Getting Started ViewSonic PF775