Weber 900 LP Owner Manual - Page 13
Step 8, Step 9
View all Weber 900 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Step 8 Install manifold bracket You will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Frame brace Manifold bracket Step 9 Install tank panel assembly and frame connector You will need: tank panel assembly, frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch wrench. Insert the tank panel tabs into the slots in the frame brace. Figure 10. Slots in frame brace Frame brace Figure 9 Tank panel tabs Figure 10 Slide tank panel up until notch at bottom of panel fits over the cross brace. Insert one bolt with washer through the hole in the bottom of the tank panel, through the wheel frame and into the end of the frame connector. Insert the other bolt with washer through the leg frame and into the other end of the frame connector. Hold the frame connector square and tighten the bolts. Figure 11. Frame connector Cross brace Figure 11 13