Weber 900 LP Owner Manual - Page 31
CAUTION: If the Spider Stopper Guards do not fit
View all Weber 900 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
d) Unlatch the Spider Stopper Guards and remove. Figure 14. i) To reinstall the burners, reverse steps c) through g). ƽCAUTION: The burner openings must be positioned properly over the valve orifices. Figure 18 (a). Check proper assembly before fastening manifold in place. Figure 18 (b). Valve (a) orifice Figure 14 e) Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down. Figure 15. View from behind cooking box Burner opening Wing nuts Figure 15 f) Slide the burner assembly out from under the guide screw and washer in the corners of the cooking box. Figure 16. Guide screw (b) Figure 18 i) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 19. Figure 16 g) Lift and twist the burner assembly slightly, to separate the crossover tube from the burners. Figure 17. Remove the burners from the cooking box. Crossover tube Venturi fin Check fit around valve Check fit around burner Figure 19 Figure 17 ƽCAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service. ƽWARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (See Step"Check for gas leaks"). 31