Weber 900 LP Owner Manual - Page 19
Step 19, Step 20
View all Weber 900 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Step 19 Install Lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 25. Hair pin cotter Hinge pin Step 20 Add tool holders, control panel and burner control knobs You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs. Hook the tool holders over the frame rail. Figure 26. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 26 (a). Push on the burner control knobs. Figure 26 (b). Insert in frame brace (a) Crossover Ignition Button Figure 25 Control panel Phillips screws/ washers (b) Tool holders Figure 26 19